30/01/2024 05:44:00

Capteur de pression - Porte - Poignée extérieure - Arrière - Gauche (retirer et remplacer)

Code de correction 11456202

Dépose

  1. Retirez l'ensemble de la poignée de porte (voir la procédure).
    Informational PurposesAn informational icon, calling your attention
    Remarque
    Il n'est pas nécessaire de retirer la poignée de porte de l'ensemble.
  2. Placez l'ensemble de la poignée sur une surface de travail souple.
  3. Retirez et mettez au rebut le joint arrière de la poignée de porte.
  4. Retirez les attaches de câble qui fixent le capteur de pression de la porte et le câblage du moteur.
  5. Retirez la vis qui fixe le capteur de pression.
  6. Débranchez le connecteur de câblage du capteur de pression de la porte.
  7. À l'aide d'une lame plate appropriée, détachez le ruban adhésif double face et retirez le capteur de la fourche.

Installation

La procédure d’installation est l’inverse de la procédure de retrait, à l’exception de ce qui suit :

  1. Nettoyez la zone touchée avant l'installation.
  2. Retirez le ruban adhésif du capteur et le fixer sur la fourche.
  3. Install a new back seal on the door handle assembly:
    1. Align the stud towers on the door handle assembly with the holes in the back seal.
    2. Press the back seal firmly to properly set the butyl seal between the back seal and the door handle assembly.
      Conseil : Use a suitable tool to apply pressure along the perimeter of the back seal to make sure proper seating of the butyl seal on the door handle assembly.
    3. Put a push nut on top of each stud. Use a deep 5 mm socket to press the push nut over the stud.
      Warning IconA warning icon, calling your attention to a possibly risky situation
      ATTENTION
      Do not use excessive force to drive the push nut into the stud.
      Informational PurposesAn informational icon, calling your attention
      Remarque
      Make sure that the push nut is firmly set into the stud without a gap between the back seal and the door handle assembly.
    4. Repeat steps a-c on the rest of the studs (total of 4 push nuts/studs per front door handle and 3 push nuts/studs per rear door handle).
    5. Use a cable tie to secure the back seal to the door handle assembly.
      Warning IconA warning icon, calling your attention to a possibly risky situation
      ATTENTION
      To avoid damage to the back seal, do not overtighten the cable tie.
      Warning IconA warning icon, calling your attention to a possibly risky situation
      ATTENTION
      To avoid damage to the door handle electrical harness, make sure proper routing of all wires.
      Front door handle Rear door handle
    6. Remove any excess tie.