03/06/2024 17:05:12

Hood Assembly (Remove and Install)

Code de correction 10100301

Dépose

  1. Remove the rear underhood apron. Voir Tablier sous le capot - arrière (retrait et remplacement) .
  2. Remove the LH and RH underhood aprons. Voir Tablier sous le capot – côté gauche (Retirer et remplacer).
  3. Mark the installed position of the hood hinges to the body.
  4. Remove the clips (x9) that attach the hood harness to the hood assembly.
  5. Disconnect the LH and RH hood washer jet electrical connectors.
  6. Disconnect the y-tubes from the LH and RH washer jet hoses.
  7. With assistance, support the weight of the hood.
  8. Release the clips (x2) and disconnect the gas struts (x2) from the hood mounting bracket ball joints.
  9. Remove the bolts (x4) that secure the LH and RH hood hinges to the body (torque 24 Nm).
  10. With assistance, remove the hood.

Installation

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Si vous utilisez cette procédure pour installer une pièce non peinte, assurez-vous d'appliquer un scellant sur toutes les coutures avant d'installer et de peindre la pièce. Veuillez consulter le Manuel de réparation en cas de collision conducteur pour obtenir plus d’informations.

La procédure d’installation est l’inverse de la procédure de retrait, à l’exception de ce qui suit :

Informational PurposesAn informational icon, calling your attention
Note
Nettoyez les zones touchées avant l'installation.
  1. Align the hood hinges to their previously marked locations.
  2. Check the alignment of the hood to the body and adjust as necessary.