06/02/2023 10:27:24
Windshield Scratch Repair
Korrekturcode 10200118
ACHTUNG
The following procedure is applicable to windshield scratch repairs only.
- Inspect the windshield for repair eligibility. See Reparatur- und Austauschrichtlinien für Windschutz- und Dachscheiben.
- Use IPA wipes to clean the windshield thoroughly.
-
Inspect the glass scratch removal kit, ensure all tools are present, and then gather shop tools and PPE.
Tipp: Es wird empfohlen, die folgenden Werkzeuge zu verwenden:
- Fender cover
- Glass scratch removal kit
- Step stool
-
Fill the water feed bottle.
AnmerkungStop at the fill line.
-
Connect the water feed tube, and then pressurize the water feed bottle.
-
Install the polishing disk on the backer pad.
AnmerkungAlign the polishing disk hole with the backer pad hole.
-
Install the backer pad on the Gforce Max tool.
-
Use a wire brush to open the polishing disk pores, position finger over the backer pad water dispensing hole, and then activate the water feed button to moisten the polishing disk.
Tipp: Es wird empfohlen, die folgenden Werkzeuge zu verwenden:
- Wire brush
-
Apply a small amount of polishing compound to the moistened polishing disk, and then scrape the compound into the disk thoroughly.
AnmerkungDo not leave compound on the surface of the disk.
-
Align the scratch in the center of the splash guard, and then install the splash guard on the windshield.
-
Use the suction cup holder to install the water feed bottle on the vehicle.
AnmerkungPosition the water feed bottle vertically near the repair area.
-
Place the fender cover on the hood, and then position the step stool near the vehicle as necessary to maintain a comfortable position when applying direct downward pressure.
ACHTUNGKeep the disk flat on the glass and battle fatigue during polishing.Tipp: Es wird empfohlen, die folgenden Werkzeuge zu verwenden:
- Fender cover
- Step stool
-
Polish the windshield in the direction of the scratch as follows:
- Grip the Gforce Max tool with both hands.
- Place the polishing disk flat on the glass.
- Pull the trigger fully, and then apply moderate downward pressure to create friction and heat.
- Move briskly over the damaged area in a circular motion.
- Press the water feed button to release more compound as needed.
-
Stop halfway through the repair and check the glass temperature.
AnmerkungLaminated glass temperature should be between 115 to 150 degrees F.
-
Re-pressurize the water feed bottle, and then repeat step 13 to finish polishing the windshield in the direction of the scratch.
-
Use water and a paper towel to clean the glass, inspect the inside of the glass for any clouding caused by residual polishing compound, and then inspect the outside of the glass for full scratch repair.
AnmerkungDo not use IPA wipes to clean the glass.Tipp: Es wird empfohlen, die folgenden Werkzeuge zu verwenden:
- Flashlight LED
-
Remove the polishing disk and backer pad from the Gforce Max tool.
ACHTUNGKeep items clean and stored in a clean container to avoid contamination and damage to glass during next use.AnmerkungIf necessary, counter hold the backer pad with the glass scratch removal kit wrench.
-
Disconnect the water feed tube, and then drain the water from the feed bottle.
AnmerkungStore all items in the glass scratch removal kit.