2024-10-09

Sensor - Wheel Speed - Front - LH (Performance) (Remove and Replace)

Code de correction 3310030002 FRT 0.24 REMARQUE : À moins d’indications explicites contraires dans la procédure, le code de correction et le temps forfaitaire ci-dessus représentent tout le travail à être fait pour cette procédure, notamment les procédures connexes. N’appliquez pas plusieurs codes de correction à la fois, à moins qu’il vous soit explicitement indiqué de le faire. REMARQUE : Consultez Temps forfaitaires pour en apprendre plus à propos des temps forfaitaires et de leur création. Vous pouvez transmettre par courriel vos commentaires relatifs aux valeurs des temps forfaitaires à LaborTimeFeedback@tesla.com. REMARQUE : Consultez Protection individuelle pour vous assurer de porter l’équipement de protection individuelle adéquat lors vous effectuez la procédure ci-dessous.

Warning IconA warning icon, calling your attention to a possibly risky situation
Avertissement
Cette procédure est une PREMIÈRE VERSION. Bien qu'elle ait été validée, des avertissements et des mises en garde pourraient manquer. Respectez les exigences de sécurité et faites preuve d’une extrême prudence lorsque vous travaillez sur ou près des systèmes et des composants haute tension. Transmettez toute correction ou remarque à ServiceDevelopment@teslamotors.com.
  1. Raise and support vehicle
    Informational PurposesAn informational icon, calling your attention
    Remarque
    Ensure vehicle is not charging
  2. Remove LH front wheel center cap
    Informational PurposesAn informational icon, calling your attention
    Remarque
    1x cap, Pull the inner side of the adjacent 2 claws on the wheel center cap by hands
  3. Loosen LH front wheel nuts
    Informational PurposesAn informational icon, calling your attention
    Remarque
    5x nuts, 21mm, 175 Nm
  4. Raise vehicle partially and lower lift onto locks
    Informational PurposesAn informational icon, calling your attention
    Remarque
    Set vehicle to a comfortable working height, Make sure there's an audible click of the locks on both sides before lowering, otherwise vehicle may tilt to the side
  5. Remove LH front wheel
    Informational PurposesAn informational icon, calling your attention
    Remarque
    5x nuts, 21mm, 175 Nm
  6. Remove the clips that partially securing LH wheel liner to fascia
    Informational PurposesAn informational icon, calling your attention
    Remarque
    9x push clips
  7. Partially remove the LF wheel liner
  8. Disconnect LH front wheel speed sensor connector
    Informational PurposesAn informational icon, calling your attention
    Remarque
    1x connector, Disengage locking tab
  9. Disconnect LH front damper solenoid connector
    Informational PurposesAn informational icon, calling your attention
    Remarque
    1x connector, Disengage locking tab
  10. Release clips securing LH front wheel speed sensor harness
    Informational PurposesAn informational icon, calling your attention
    Remarque
    4x tree clips, 1x rubber grommet
  11. Release bolt securing LH front wheel speed sensor to knuckle
    Informational PurposesAn informational icon, calling your attention
    Remarque
    1x bolt, T30, 5 Nm
  12. Remove LH front wheel speed sensor from knuckle
  13. Install LH front wheel speed sensor into knuckle
  14. Install bolt securing LH front wheel speed sensor to knuckle
    Informational PurposesAn informational icon, calling your attention
    Remarque
    1x bolt, T30, 5 Nm
  15. Install clips securing LH front wheel speed sensor harness
    Informational PurposesAn informational icon, calling your attention
    Remarque
    4x tree clips, 1x rubber grommet, Ensure harness is routed correctly to avoid harness contact with moving suspension components
  16. Connect LH front wheel speed sensor connector
    Informational PurposesAn informational icon, calling your attention
    Remarque
    1x connector, Engage locking tab
  17. Connect LH front damper solenoid
    Informational PurposesAn informational icon, calling your attention
    Remarque
    1x connector, Engage locking tab
  18. Install the LF wheel liner
  19. Install clips securing LH wheel liner to fascia
    Informational PurposesAn informational icon, calling your attention
    Remarque
    9x push clips
  20. Install LH front wheel
    Informational PurposesAn informational icon, calling your attention
    Remarque
    5x nuts, 21mm, 175 Nm, Start lug nuts by hand before using power tool
  21. Lower vehicle until tires are touching ground
    Informational PurposesAn informational icon, calling your attention
    Remarque
    Raise lift off locks, then hold lock release lever to keep locks free while vehicle is lowered
  22. Torque LH front wheel
    Informational PurposesAn informational icon, calling your attention
    Remarque
    5x nuts, 21mm, 175 Nm
  23. Install LH front wheel center cap
    Informational PurposesAn informational icon, calling your attention
    Remarque
    1x cap, Ensure that the cap is installed in place
  24. Remove lift arms from below vehicle
    Informational PurposesAn informational icon, calling your attention
    Remarque
    Lower rack arms fully and remove them from under vehicle