2024-11-18

Capteur – radar – avant (Retravaillé)

Code de correction 17201612 0.48 REMARQUE : À moins d’indications explicites contraires dans la procédure, le code de correction et le temps forfaitaire ci-dessus représentent tout le travail à être fait pour cette procédure, notamment les procédures connexes. N’appliquez pas plusieurs codes de correction à la fois, à moins qu’il vous soit explicitement indiqué de le faire. REMARQUE : Consultez Temps forfaitaires pour en apprendre plus à propos des temps forfaitaires et de leur création. Vous pouvez transmettre par courriel vos commentaires relatifs aux valeurs des temps forfaitaires au LaborTimeFeedback@tesla.com. NOTE: Consultez Protection individuelle pour vous assurer de porter l’ÉPI approprié lorsque vous effectuez la procédure ci-dessous.

Warning IconA warning icon, calling your attention to a possibly risky situation
Avertissement
Cette procédure est une PREMIÈRE VERSION. Bien qu'elle ait été validée, des avertissements et des mises en garde pourraient manquer. Respectez les exigences de sécurité et faites preuve d’une extrême prudence lorsque vous travaillez sur ou près des systèmes et des composants haute tension. Transmettez toute correction ou remarque à ServiceDevelopment@teslamotors.com.
  1. Open the LH front door.
  2. Lower the LH front window.
  3. Remove the front fascia assembly. See Ensemble de carénage - avant (retrait et installation).
  4. Disconnect the front radar sensor connector.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Small flat head screwdriver
  5. Install the dummy plugs (x2) on the front radar sensor and the sensor connector.
  6. Use harness tape to attach the front radar sensor connector to the frunk harness.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Harness tape
  7. Install the front fascia assembly. See Ensemble de carénage - avant (retrait et installation).
  8. Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3.0 (connecter et déconnecter).
  9. In Toolbox, click the Dashboards tab, Infotainment Dashboard, and then Vehicle Configuration.
    Informational PurposesAn informational icon, calling your attention
    Remarque
    Configuration values should load automatically, if not click Read Config and Run to load configuration values.
  10. In Toolbox, navigate to "forwardRadarHw", click on the current front radar configuration, and then change the configuration to "NONE".
  11. In Toolbox, click Apply Changes and Run to save the updated front radar configuration.
    Informational PurposesAn informational icon, calling your attention
    Remarque
    The center display will reboot and Toolbox connection will be lost. Select "X" at top right of window to close once complete.
  12. Disconnect the laptop with Toolbox 3 from the vehicle. See Toolbox 3.0 (connecter et déconnecter).
  13. Raise the LH front window.
  14. Close the LH front door.