2026-08-09

Applique - hayon (international) (retrait et remplacement)

Code de correction 12207022 0.12 REMARQUE : À moins d’indications explicites contraires dans la procédure, le code de correction et le temps forfaitaire ci-dessus représentent tout le travail à être fait pour cette procédure, notamment les procédures connexes. N’appliquez pas plusieurs codes de correction à la fois, à moins qu’il vous soit explicitement indiqué de le faire. REMARQUE : Consultez Temps forfaitaires pour en apprendre plus à propos des temps forfaitaires et de leur création. NOTE : Consultez Protection individuelle pour veiller à porter l’ÉPI approprié lorsque vous effectuez la procédure ci-dessous.

Remarque
Cette procédure concerne la version Global Refresh de cette pièce. La procédure pour la version originale de cette pièce est ici : Applique - hayon (retrait et remplacement).

Retirer

  1. Carefully release the clips (x5) that attach the liftgate applique to the liftgate, and then remove the applique from the vehicle.
    Remarque
    Use a plastic trim tool to release the clips.

Installer

  1. Clean the mating surfaces of the liftgate applique with an Isopropyl Alcohol (IPA) wipe.
    Remarque
    Clean away any residue.
    Remarque
    Use your thumb to help roll off the adhesive.
    Remarque
    Allow 1 minute for the IPA to dry before continuing to the next step.
  2. Install the applique tape onto the applique bracket.
    ATTENTION
    Be wary not to cover the rear facing camera.
    Remarque
    Peel away the tape when the liftgate applique is to be installed
  3. Install the liftgate applique.
    Remarque
    x5 clips.
    Remarque
    Peel away the tape when ready to install the applique.
    Remarque
    Align the applique using pin. Start by fastening the center clips, and then work your way out.
    Remarque
    Use the seam roller to seat the adhesive areas.