2024-02-09

Répétiteur latéral - avant - gauche (HW4) (retrait et remplacement)

Code de correction 17403702 0.12 REMARQUE : À moins d’indications explicites contraires dans la procédure, le code de correction et le temps forfaitaire ci-dessus représentent tout le travail à être fait pour cette procédure, notamment les procédures connexes. N’appliquez pas plusieurs codes de correction à la fois, à moins qu’il vous soit explicitement indiqué de le faire. REMARQUE : Consultez Temps forfaitaires pour en apprendre plus à propos des temps forfaitaires et de leur création. Vous pouvez transmettre par courriel vos commentaires relatifs aux valeurs des temps forfaitaires au LaborTimeFeedback@tesla.com. NOTE: Consultez Protection individuelle pour vous assurer de porter l’ÉPI approprié lorsque vous effectuez la procédure ci-dessous.

  • 2024-02-05: Ajout d'un avertissement pour envelopper les bornes de la camera et du faisceau de câbles pour éviter qu'elles n'entrent en contact avec de l'eau ou d'autres solutions susceptibles de les endommager.
Warning IconA warning icon, calling your attention to a possibly risky situation
Avertissement
Cette procédure est une PREMIÈRE VERSION. Bien qu'elle ait été validée, des avertissements et des mises en garde pourraient manquer. Respectez les exigences de sécurité et faites preuve d’une extrême prudence lorsque vous travaillez sur ou près des systèmes et des composants haute tension. Transmettez toute correction ou remarque à ServiceDevelopment@teslamotors.com.

Retirer

  1. Apply masking tape to the LH front fender assembly at the edges of the LH front side repeater.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Nous recommandons l’utilisation des outils suivants :
    • Masking tape
  2. Release the push clip that attaches the LH front side repeater to the LH front fender assembly.
    Figure 1. Inside fender view is for clarity only and access is not required for procedure
    1. Apply light constant pressure towards the fender at the rear of the side repeater, and keep pressure applied until the side repeater is released from the fender.
    2. Slide the side repeater approximately 5 mm towards the rear of the vehicle until the front clip is clear of the fender.
    3. Pull the front end of the side repeater away from the fender until the front clip releases from the fender.
    4. Slide the side repeater towards the front of the vehicle until the rear hook clip releases from the fender.
  3. Disconnect the LH front side repeater connectors (x2).
    Informational PurposesAn informational icon, calling your attention
    Remarque
    Press down on the lock release and pull the connector away from the side repeater camera. Release the red locking tab and press down to disconnect the side repeater connector.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    ATTENTION
    Enveloppez les bornes de la camera et du faisceau de câbles pour éviter qu'elles n'entrent en contact avec de l'eau ou d'autres solutions susceptibles de les endommager.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Nous recommandons l’utilisation des outils suivants :
    • Pocket screwdriver
  4. Remove the LH front side repeater from the vehicle.
  5. Remove the LH front side repeater camera. See Répétiteur latéral - avant - gauche (HW4) (retrait et remplacement).

Installer

  1. Install the LH front side repeater camera. See Répétiteur latéral - avant - gauche (HW4) (retrait et remplacement).
  2. Connect the LH front side repeater connectors (x2).
    Informational PurposesAn informational icon, calling your attention
    Remarque
    Remove the tape first, if present.
    Informational PurposesAn informational icon, calling your attention
    Remarque
    Secure the side repeater connectors, and then engage the red locking tab on the side repeater connector.
  3. Open the LH front door.
  4. Réinitialisez le système d'assistance conducteur (DAS).
    1. Déverrouillez la passerelle du véhicule. Voir Passerelle (déverrouiller).
    2. Dans le menu du mode Entretien à l’écran tactile, touchez Assistance conducteur > Caméras > Réinitialiser DAS.
    3. Sur le diagramme des caméras de l'écran tactile, vérifiez que le bouton Réinitialiser le DAS est surligné en vert et que tous les composants du DAS affichent un voyant d'état vert.
      Informational PurposesAn informational icon, calling your attention
      Remarque
      Vérifiez et corrigez tout composant DAS illuminé en rouge.
  5. Close the LH front door.
  6. Install the push clip that attaches the LH front side repeater to the LH front fender assembly.
    Informational PurposesAn informational icon, calling your attention
    Remarque
    Ensure all tabs are intact and installed in place correctly.
    1. Insert the side repeater rear hook clip into the repeater slot in the fender, apply light constant pressure at the rear of the repeater, and then keep pressure until the repeater is installed.
    2. Slide the side repeater rearwards until the rear hook clip engages the fender and the front clip clears the edge of the repeater slot in the fender.
    3. Press on the front of the side repeater until the front clip is inside of the repeater slot and keep pressure on the front and rear of the repeater until installation is complete.
    4. Slide the side repeater towards the front of the vehicle until the front clip engages the fender, and then release pressure on the repeater.
  7. Remove the masking tape from the LH front fender assembly at the edges of the LH front side repeater.