Code de correction 17451012 0.48 REMARQUE : À moins d’indications explicites contraires dans la procédure, le code de correction et le temps forfaitaire ci-dessus représentent tout le travail à être fait pour cette procédure, notamment les procédures connexes. N’appliquez pas plusieurs codes de correction à la fois, à moins qu’il vous soit explicitement indiqué de le faire. REMARQUE : Consultez Temps forfaitaires pour en apprendre plus à propos des temps forfaitaires et de leur création. Vous pouvez transmettre par courriel vos commentaires relatifs aux valeurs des temps forfaitaires au LaborTimeFeedback@tesla.com. NOTE: Consultez Protection individuelle pour vous assurer de porter l’ÉPI approprié lorsque vous effectuez la procédure ci-dessous.

1. Open LH front door
2. Lower LH front window
3. Press brake pedal to turn on drive rails
4. Set air suspension ride height to “Very High”
   Remarque

   Using center display > Controls > Suspension > ''Very High''
5. Turn wheel fully to the right
6. Open hood
   Remarque

   Via Center Display > Controls > Frunk Open
7. Remove rear underhood apron
   Remarque

   8x clips

   

   

8. Remove LH underhood apron
   Remarque

   10x clips

   

   

9. Remove RH underhood apron
   Remarque

   10x clips

   

   

10. Remove front underhood apron
    Remarque

    7x clips

    

    

11. Remove bolts securing fascia bracket to carrier
    Remarque

    6x bolts, 10mm, 4 Nm

    

12. Remove push clips securing LH front wheel arch liner to fascia and move to the side for access
    Remarque

    5x push clips, Shift bottom of liner down and flex top of liner against tire

    

    

    

13. Remove bolt securing front fascia to LH fender bracket
    Remarque

    1x bolt, T25, 5 Nm

    

14. Press brake pedal to turn on drive rails

    

15. Turn wheel fully to the left

    

16. Remove push clips securing RH front wheel arch liner to fascia and move to the side for access
    Remarque

    5x push clips, Shift bottom of liner down and flex top of liner against tire

    

    

    

17. Remove bolt securing front fascia to RH fender bracket
    Remarque

    1x bolt, T25, 5 Nm

    

18. Power off vehicle from center display
    Remarque

    Via Controls > Safety & Security > Power Off

    

19. Disconnect LV battery connector and First Responder Loop
    Remarque

    2x connectors, Lift up and release green locking tab, Pull black connector lock outwards to release connection

    

    

    

    

20. Disconnect front fascia harness
    Remarque

    2x connectors, Pull red tab to disengage lock then disconnect, Located behind RH wheel arch liner

    

21. Release front fascia valance from front aero shield
    Remarque

    3x bolts, 10mm, 6 Nm, 2x clips, 2x datums, Do not remove 3x middle bolts

    

    

22. Release fascia from fender brackets and pull forward to remove from vehicle
    Remarque

    Set fascia on protected surface, Recommend assistance

    

    

23. Disconnect battery backed siren connector
    Remarque

    1x connector

    

24. Remove bolt securing battery backed siren to front bumper beam complete
    Remarque

    1x bolt, 10mm, 8 Nm

    

    

25. Install bolt securing battery backed siren to front bumper beam complete
    Remarque

    1x bolt, 10mm, 8 Nm

    

    

26. Connect battery backed siren connector
    Remarque

    1x connector

    

27. Install front fascia onto vehicle and secure fascia to fender brackets
    Remarque

    Recommend Assistance, Route fascia harness while installing, Verify front fascia valance sits under front aero shield before proceeding

    

    

28. Apply Loctite 222 to fasteners and secure front fascia valance to front aero shield
    Remarque

    3x bolts, 10mm, 6 Nm, 2x clips, 2x datums, Insert valance datums into aero shield holes, Do not remove 3x middle bolts

    

    

    

29. Connect front fascia harness
    Remarque

    2x connectors, Engage locking tab, Located behind RH wheel arch liner

    

30. Install bolt securing fascia to RH fender bracket
    Remarque

    1x bolt, T25, 5 Nm

    

31. Install push clips securing RH front wheel liner to fascia
    Remarque

    5x push clips

    

    

32. Connect First Responder Loop and LV battery connector
    Remarque

    2x connectors Secure FRL first, Seat LV battery connection and push black connector lock inwards to secure, Engage green locking tab when fully seated

    

    

    

    

33. Press brake pedal to turn on drive rails

    

34. Turn wheel fully to the right
35. Install bolt securing fascia to LH fender bracket
    Remarque

    1x bolt, T25, 5 Nm

    

36. Install push clips securing LH front wheel liner to fascia
    Remarque

    5x push clips

    

    

37. Install bolts securing fascia bracket to carrier
    Remarque

    6x bolts, 10mm, 4 Nm

    

38. Install RH underhood apron
    Remarque

    10x clips

    

    

39. Install LH underhood apron
    Remarque

    10x clips

    

    

40. Install rear underhood apron
    Remarque

    8x clips

    

    

41. Close hood
    Remarque

    Press firmly in green highlighted areas (see image), Damage may result from pressure elsewhere on hood

    

42. Press brake pedal to turn on drive rails
43. Turn steering wheel back to center
44. Set air suspension ride height to “Medium”
    Remarque

    Using center display, Controls > Suspension > ''Medium'
45. Close LH front door