2026-07-13

LV-Erhaltungslader (Verbinden und Trennen)

Korrekturcode 17010500 0.06 HINWEIS: Sofern im Verfahren nicht ausdrücklich anders angegeben, spiegeln der obige Korrekturcode und die FRT den gesamten für die Durchführung dieses Verfahrens erforderlichen Aufwand wider, einschließlich der damit verbundenen Verfahren. Schichten Sie keine Korrekturcodes, wenn Sie nicht ausdrücklich dazu aufgefordert werden. HINWEIS: Unter Richtzeiten erfahren Sie mehr über FRTs und wie sie erstellt werden. HINWEIS: Siehe Persönlicher Schutz, um sicherzustellen, dass Sie die richtige persönliche Schutzausrüstung tragen, wenn Sie das folgende Verfahren durchführen. HINWEIS: Siehe Maßnahmen zur Ergonomie für sichere und gesunde Arbeitsmethoden.

  • 2026-07-07: Deleted steps to disconnect/connect the 12V/LV battery.
  • 2025-12-05: Added a caution to make sure windows are not moved for at least 1 minute before disconnecting the LV maintainer.
  • 2023-10-31: Updated the location to attach the maintainer's negative clamp with new images attached.
Warning IconA warning icon, calling your attention to a possibly risky situation
ACHTUNG
Stellen Sie vor dem Trennen des LV-Erhaltungsladers sicher, dass die Fenster mindestens 1 Minute lang nicht bewegt wurden. Wird vor dem Trennen diese Zeit nicht abgewartet, kann es zu Komponentenschäden kommen.

Verbinden

  1. Enable Service Mode. See Service-Modus.
  2. Release the positive terminal cover.
  3. Secure the LV maintainer positive terminal to the jump post.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    ACHTUNG
    To avoid damaging the vehicle, DO NOT allow the positive cable to make contact with other metal components.
  4. Secure the LV maintainer negative terminal to the VCFront bracket bolt (as indicated on the VCFront label).
  5. Connect the LV maintainer to a power supply, and then power on.

Disconnect

  1. Power off the LV maintainer.
  2. Release the negative terminal connection from the vehicle first, and then release the positive terminal.
  3. Install the positive terminal cover.
  4. Confirm that the LV battery State Of Charge (SOC) is above 73% and Battery State is Charge or Standby.
    Informational PurposesAn informational icon, calling your attention
    Anmerkung
    If the LV battery SOC is below 73% confirm that Battery State is Charge and Pack Current is positive, Via Tesla Garage > LV.