2026-08-09

Trim - Cantrail - Roof Rail - LH (Rework)

Código de corrección 10100504407, 10100504507 0.20 NOTA: Salvo que se indique lo contrario explícitamente en el procedimiento, el código de corrección y el FRT mencionados anteriormente reflejan todo el trabajo necesario para realizar este procedimiento, incluidos los procedimientos vinculados. No acumule códigos de corrección a menos que se le indique explícitamente que lo haga. NOTA: Consulte Tiempos de tarifa plana para obtener más información sobre los FRT y cómo se crean. NOTA: Consulte Protección personal para asegurarse de llevar el EPI adecuado al realizar el siguiente procedimiento. NOTA: Consulte Precauciones ergonómicas para ver prácticas de trabajo seguras.

Aviso
Este procedimiento están en fase PRELIMINAR. Aunque se ha validado, es posible que falten advertencias y precauciones. Siga los requisitos de seguridad y tenga mucho cuidado cuando trabaje en sistemas y componentes de alta tensión o cerca de ellos.
Nota
If this rework is performed, add Correction Code 10100504407 for the LH side and/or 10100504507 for the RH side.
Nota
This rework is performed when the roof rail cantail trim has already been removed from the vehicle. See Trim - Cantrail - Roof Rail - LH (Remove and Install) for cantrail trim remove and install procedure.
  • 2026-04-08: Released new procedure.

Conectar Procedimiento

  1. Use an 8mm drill bit to enlarge the LH roof rail cantrail trim front mounting hole.
    PRECAUCIÓN
    Make sure the drill bit does not go more than 1 inch into the panel.
    Nota
    Verify the size with taper step gauge.
  2. Clean the reworked LH roof rail cantrail trim mounting hole.
    Nota
    Remove any burrs caused by drilling, and then wipe the inside and outside with IPA to clean surface of contaminate. Allow 1 minute to dry.
  3. Apply masking tape around the reworked LH roof rail cantrail trim mounting hole.
    Nota
    Make sure to cover any stainless steel and glass surfaces to prevent paint overspray.
  4. Apply SEM ez coat to the LH roof rail cantrail trim rework location.
    Nota
    Shake the can for 1 minute before application.
    Nota
    Apply 2 coats of SEM ez coat. Allow ez coat to dry for 5-10 minutes between coats.
    Nota
    Allow 30 minutes of dry time after the second coat.
  5. Remove the masking tape.