2026-05-27

Bed Side Wall - RH (Standard) (Remove and Install)

Código de corrección NEW NOTA: Salvo que se indique lo contrario explícitamente en el procedimiento, el código de corrección y el FRT mencionados anteriormente reflejan todo el trabajo necesario para realizar este procedimiento, incluidos los procedimientos vinculados. No acumule códigos de corrección a menos que se le indique explícitamente que lo haga. NOTA: Consulte Tiempos de tarifa plana para obtener más información sobre los FRT y cómo se crean. NOTA: Consulte Protección personal para asegurarse de llevar el EPI adecuado al realizar el siguiente procedimiento. NOTA: Consulte Precauciones ergonómicas para ver información sobre prácticas de trabajo seguras.

Warning IconA warning icon, calling your attention to a possibly risky situation
Aviso
Este procedimiento están en fase PRELIMINAR. Aunque se ha validado, es posible que falten advertencias y precauciones. Siga los requisitos de seguridad y tenga mucho cuidado cuando trabaje en sistemas y componentes de alta tensión o cerca de ellos.
  • 2026-05-08: Released new procedure.
  1. Abra la cubierta de la plataforma de carga.
  2. Abra el portón trasero.
  3. Remove the bed floor. See Bed Floor Assembly (Long Range) (Remove and Install).
  4. Remove the RH sail applique. See Sail Applique - RH (Remove and Install) (Post 11/4/2024).
  5. Remove the RH tonneau water management seal. See Water Management Seal - LH - Center - Tonneau (Remove and Install).
  6. Remove the RH upper bed side wall. See Bed Side Wall Assembly - Upper - LH (Remove and Install).
  7. Remove the RH rear bed closeout. See Bed Closeout - Rear - LH (Remove and Install).
  8. Remove RH bed side wall
    Informational PurposesAn informational icon, calling your attention
    Nota
    1x bolt, 15mm, 46 Nm, 2x bolts, T40, 36 Nm, 4x bolts, 10mm, 11 Nm, 2x nuts, 10mm, 7 Nm, 4x clips, 1x fastener cover, 1x connector, Release locking tabs
  9. Install RH bed side wall
    Informational PurposesAn informational icon, calling your attention
    Nota
    1x bolt, 15mm, 46 Nm, 2x bolts, T40, 36 Nm, 4x bolts, 10mm, 11 Nm, 2x nuts, 10mm, 7 Nm, 4x clips, 1x fastener cover, 1x connector, Recommend assistance
  10. Install the RH rear bed closeout. See Bed Closeout - Rear - LH (Remove and Install).
  11. Install the RH upper bed side wall. See Bed Side Wall Assembly - Upper - LH (Remove and Install).
  12. Install the RH tonneau water management seal. See Water Management Seal - LH - Center - Tonneau (Remove and Install).
  13. Install the RH sail applique. See Sail Applique - RH (Remove and Install) (Post 11/4/2024).
  14. Install the bed floor. See Bed Floor Assembly (Long Range) (Remove and Install).
  15. Cierre la cubierta de la plataforma de carga.
  16. Abra el portón trasero.