2025-02-09

Camera - Forward Facing (Pitch Verification) (Test/Adjust)

Código de corrección 17221000 0.24 NOTA: Salvo que se indique lo contrario explícitamente en el procedimiento, el código de corrección anterior y el FRT reflejan todo el trabajo necesario para realizar este procedimiento, incluidos los procedimientos vinculados. No acumule códigos de corrección a menos que se le indique explícitamente que lo haga. NOTA: Consulte Tiempos de tarifa plana para obtener más información sobre los FRT y cómo se crean. Para enviar sus comentarios sobre los valores de FRT, escriba a LaborTimeFeedback@tesla.com. NOTA: Consulte Protección personal para asegurarse de llevar el EPI adecuado al realizar el siguiente procedimiento.

  • 2025-01-28: Fixed correction code and title.
  • 2024-10-24: Added step to remove overhead console assembly in rearview mirror beauty cover procedure link.
  • 2024-09-12: Added steps to adjust camera pitch.
  • 2024-08-28: Added missing step to set the ride height to "Medium".
Warning IconA warning icon, calling your attention to a possibly risky situation
Aviso
Este procedimiento están en fase PRELIMINAR. Aunque se ha validado, es posible que falten advertencias y precauciones. Siga los requisitos de seguridad y tenga mucho cuidado cuando trabaje en sistemas y componentes de alta tensión o cerca de ellos. Envíe sus correcciones y comentarios a ServiceDevelopment@teslamotors.com.

Conectar Procedimiento

  1. Abra la puerta delantera izquierda y baje la ventanilla delantera izquierda.
  2. Using the vehicle touchscreen, set the vehicle ride height to "Medium".
  3. Coloque el vehículo en el Modo de servicio. Consulte Modo de servicio.
  4. Desbloquee la puerta de enlace del vehículo. Consulte Puerta de enlace (Desbloquear).
  5. Park the vehicle on a flat surface with at least 3.5 feet of clearance in front of the vehicle.
  6. Set up the tripod so that the bottom of the target is 3 ft (91.4cm) from the ground.
  7. Place the target against the front fascia centered to the vehicle.
  8. Make sure that the target is on flat ground by examining the bubble level on the back of the target.
  9. Apply a piece of red tape on the target referencing the camera height.
    Informational PurposesAn informational icon, calling your attention
    Nota
    The top of the tape should be target height 165 cm.
  10. On the vehicle touchscreen, navigate to Service Mode > Driver Assist > Cameras > Camera Preview > Pitch verification > Main camera > Wide Camera to verify the front camera pitch.
  11. Review the main and wide images. The top of the tape should coincide with the blue horizontal line.
    • If the tape is between the green lines, the camera pitch is within specification. Skip to step 19.
    • If the forward facing camera pitch is out of specification, proceed to the next step to adjust.
  12. Remove the rear view mirror beauty cover. See Rearview Mirror - Beauty Cover (Remove and Install).
  13. On the vehicle touchscreen, navigate to Service Mode Plus > Driver Assist > Cameras > Clear Camera Calibration, and then tap Run to clear the front camera calibration.
  14. Navigate to Service Mode Plus > Driver Assist > Cameras > Reset DAS, and then tap Run to reset DAS.
  15. Navigate to Service Mode Plus > Driver Assist > Cameras > Ping DAS, and then tap Run to ping DAS.
  16. Use a pitch adjustment wrench (PN: 1448868-00-B) to adjust the camera pitch.
    Informational PurposesAn informational icon, calling your attention
    Nota
    Clockwise pitches the camera upward. Counter-clockwise pitches the camera downward. 1 rotation can adjust pitch 0.5 - 1.5 degrees.
  17. Review the main and wide images. The top of the tape should coincide with the blue horizontal line.
    • If the tape is between the green lines, the camera pitch is within specification. Continue to the next step.
    • If the forward facing camera pitch is out of specification, repeat step 13 through step 17 to readjust.
  18. Install the rear view mirror beauty cover. See Rearview Mirror - Beauty Cover (Remove and Install).
  19. Remove the target from the front of the vehicle.
  20. Salga del Modo de servicio. Consulte Modo de servicio.
  21. Suba la ventanilla delantera izquierda y cierre la puerta delantera izquierda.