2025-03-03

2nd Row Outboard B-Cover - RH (Remove and Replace)

Código de corrección 1308005131, 1308005132 0.12 NOTA: Salvo que se indique lo contrario explícitamente en el procedimiento, el código de corrección anterior y el FRT reflejan todo el trabajo necesario para realizar este procedimiento, incluidos los procedimientos vinculados. No acumule códigos de corrección a menos que se le indique explícitamente que lo haga. NOTA: Consulte Tiempos de tarifa plana para obtener más información sobre los FRT y cómo se crean. Para enviar sus comentarios sobre los valores de FRT, escriba a LaborTimeFeedback@tesla.com. NOTA: Consulte Protección personal para asegurarse de llevar el EPI adecuado al realizar el siguiente procedimiento.

Warning IconA warning icon, calling your attention to a possibly risky situation
Aviso
Este procedimiento están en fase PRELIMINAR. Aunque se ha validado, es posible que falten advertencias y precauciones. Siga los requisitos de seguridad y tenga mucho cuidado cuando trabaje en sistemas y componentes de alta tensión o cerca de ellos. Envíe sus correcciones y comentarios a ServiceDevelopment@teslamotors.com.
  1. Open RH rear door
    Informational PurposesAn informational icon, calling your attention
    Nota
    Push RH C-pillar door trigger to release
  2. Lower RH rear window
  3. Partially release RH rear primary door seal
  4. Remove RH lower C-pillar trim
    Informational PurposesAn informational icon, calling your attention
    Nota
    3x clips, 7x tabs, 4x datums, Starting at door sill pull upward then forward to release, Leave trim attached to seat belt
  5. Remove 2nd row RH outboard seatback bolster
    Informational PurposesAn informational icon, calling your attention
    Nota
    2x tabs, 1x datum, 3x clips, Release tab near the bottom of RH outboard bolster, Partially release RH 2nd row shoulder cover and remove bolster from vehicle
  6. Remove clip securing RH 2nd row seat outboard B cover assembly
    Informational PurposesAn informational icon, calling your attention
    Nota
    1x clip, Position aside for access to clip
  7. Release RH 2nd row seat cushion release buckle strap from lever and remove RH 2nd row seat outboard B cover assembly from vehicle
    Informational PurposesAn informational icon, calling your attention
    Nota
    Compress material then twist away to release from groove
  8. Position RH 2nd row seat outboard B cover assembly into vehicle and secure RH 2nd row seat cushion release buckle strap to lever
    Informational PurposesAn informational icon, calling your attention
    Nota
    Slide onto lever then compress material and twist inward to secure into groove
  9. Install clip securing RH 2nd row seat outboard B cover assembly
    Informational PurposesAn informational icon, calling your attention
    Nota
    1x clip, Ensure strap is not twisted
  10. Install 2nd row seatback RH outboard bolster
    Informational PurposesAn informational icon, calling your attention
    Nota
    2x tabs, 1x datum, 3x clips, Position LH outboard bolster into place, Ensure all clips and tabs are fully engaged, Replace any missing or damaged clips, Secure LH 2nd row shoulder cover, Perform push-pull-push test datums
  11. Install LH lower C-pillar trim
    Informational PurposesAn informational icon, calling your attention
    Nota
    3x clips, 7x tabs, 4x datums
  12. Secure RH rear primary door seal
  13. Raise RH rear window
  14. Close RH rear door