2025-10-10

Deflector Clip - Tonneau - LH (Remove and Replace)

Código de corrección NEW 0.80 NOTA: Salvo que se indique lo contrario explícitamente en el procedimiento, el código de corrección anterior y el FRT reflejan todo el trabajo necesario para realizar este procedimiento, incluidos los procedimientos vinculados. No acumule códigos de corrección a menos que se le indique explícitamente que lo haga. NOTA: Consulte (FRT)Tiempos de tarifa plana para obtener más información sobre los FRT y cómo se crean. Para enviar sus comentarios sobre los valores de FRT, escriba a ServiceManualFeedback@tesla.com. NOTA: Consulte Protección personal para asegurarse de llevar el EPI adecuado al realizar el siguiente procedimiento. NOTA: Consulte Precauciones ergonómicas para ver información sobre prácticas de trabajo seguras.

Warning IconA warning icon, calling your attention to a possibly risky situation
Aviso
Este procedimiento están en fase PRELIMINAR. Aunque se ha validado, es posible que falten advertencias y precauciones. Siga los requisitos de seguridad y tenga mucho cuidado cuando trabaje en sistemas y componentes de alta tensión o cerca de ellos.
  • 2025-10-07: Released new procedure.

Retirar

  1. Remove the tonneau slats. See Slat System - Tonneau (Remove and Install).
  2. Remove LH End Slat Bolt, Roller, Tonneau Service Kit
    Informational PurposesAn informational icon, calling your attention
    Nota
    2x slat bolts, 2x sleeves, 4x rollers, 1x Y-React Clip, Carefully pull outwards to release slat bolts from slats

Instalar

  1. Install LH deflector clip
    Informational PurposesAn informational icon, calling your attention
    Nota
    1x Clip,Insert into end slat.
  2. Install LH End Slat Bolt, Roller, Tonneau Service Kit
    Informational PurposesAn informational icon, calling your attention
    Nota
    2x slat bolts, 2x sleeves, 4x rollers, 1x Y-React Clip, Insert slat bolts into slats until fully engaged
  3. Install the tonneau slats. See Slat System - Tonneau (Remove and Install). After Manually guiding the remaining tonneau slts and chain onto the bed rails, and before securing the tonneau chain onto the motors, perform the following steps:
    1. Re-establish vehicle connection to Toolbox 3.
    2. Select "Actions" tab and search for "Tonneau".
    3. Select "Tonneau Cover Calibration", click "Run", and allow routine to complete.
      Informational PurposesAn informational icon, calling your attention
      Nota
      Select "X" at top right of window to close once complete.
    4. Disconnect Toolbox 3 from vehicle and remove laptop.