2024-11-08

Windshield Washer Bottle and Pump - Washer Tank Assembly (Remove and Install)

Código de corrección NEW NOTA: Salvo que se indique lo contrario explícitamente en el procedimiento, el código de corrección anterior y el FRT reflejan todo el trabajo necesario para realizar este procedimiento, incluidos los procedimientos vinculados. No acumule códigos de corrección a menos que se le indique explícitamente que lo haga. NOTA: Consulte Tiempos de tarifa plana para obtener más información sobre los FRT y cómo se crean. Para enviar sus comentarios sobre los valores de FRT, escriba a LaborTimeFeedback@tesla.com. NOTA: Consulte Protección personal para asegurarse de llevar el EPI adecuado al realizar el siguiente procedimiento.

  • 2024-10-7: Added step to fill washer tank with washer fluid after install.
Warning IconA warning icon, calling your attention to a possibly risky situation
Aviso
Este procedimiento están en fase PRELIMINAR. Aunque se ha validado, es posible que falten advertencias y precauciones. Siga los requisitos de seguridad y tenga mucho cuidado cuando trabaje en sistemas y componentes de alta tensión o cerca de ellos. Envíe sus correcciones y comentarios a ServiceDevelopment@teslamotors.com.

Retirar

  1. Remove the frunk assembly. See Frunk Assembly (Remove and Install).
  2. Release the clip that attaches the windshield wiper washer hose to the megabeam washer hose, and then disconnect the hoses.
  3. Release the clip that attaches the camera nozzle hose to the washer pump, and then disconnect the hose from the washer pump.
  4. Release the harness clips (x2) from the washer tank assembly.
  5. Disconnect the washer pump electrical connector.
  6. Disconnect the washer level sensor electrical connector.
  7. Remove the bolts (x3) that attach the washer tank assembly to the vehicle, and then remove the assembly from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Se recomienda utilizar las siguientes herramientas:
    • Vaso de 10 mm

Instalar

  1. Position the washer tank assembly into the vehicle, and then install the bolts (x3) that attach the assembly to the vehicle.
    8 Nm (5.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Se recomienda utilizar las siguientes herramientas:
    • Vaso de 10 mm
  2. Connect the washer level sensor electrical connector.
  3. Connect the washer pump electrical connector.
  4. Secure the harness clips (x2) to the washer tank assembly.
  5. Connect the camera nozzle hose to the washer pump, and then secure the clip.
  6. Connect the megabeam windshield washer hose to the washer hose assembly, and then secure the clip.
  7. Install the frunk assembly. See Frunk Assembly (Remove and Install).
  8. Fill washer tank with washer fluid.