2023-12-20

Insulator - Motor Bay - Rear (7 Seat) (Remove & Replace)

Code de correction 15308532

Dépose

  1. Open both falcon doors.
  2. Open the trunk.
  3. Remove the rear load floor.
  4. Remove the LH and RH trunk sill side trim. See Garniture - coffre arrière - latérale - gauche (retrait et remplacement).
  5. Remove the rear trunk sill trim. See Garniture - coffre arrière - seuil (retrait et remplacement).
  6. Remove the rear trunk board.
  7. Remove the trunk floor carpet.
  8. Remove the 3rd row seat assembly. See .
  9. Chase bolts holes to clean out the old Locktite.
  10. Remove LH and RH rear welcome plate. See Plaque de bienvenue - gauche (retrait et remplacement).
  11. Remove the LH and RH lower C-panel trim. See Garniture – montant arrière – inférieure – gauche (retrait et remplacement).
  12. Remove the 2nd row floor panel #3.
  13. Remove the LH Lava tube foam piece covering the charger cable.
  14. Remove the RH Lava tube foam piece.
  15. Make a relief cut to remove the motor bay insulator from around the HV cables.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    ATTENTION
    take care to not damage HV cables.
  16. Lift up the motor bay insulator and remove it from the vehicle.

Installation

La procédure d'installation se fait en suivant l'ordre inverse de la procédure de retrait.