03/06/2024 17:05:14

Brake Pad Kit - Front (Remove and Replace)

Code de correction 33010702

  • 2024-03-19: Added an image of lubricating the caliper pad slides.
  • 2023-03-28: Updated grease in install section.
Warning IconA warning icon, calling your attention to a possibly risky situation
Avertissement
Si le véhicule est doté de la suspension pneumatique, activez le mode « Jack » (Cric) sur l'écran tactile avant de soulever le véhicule, puis installez des chandelles.

Special tools recommended for this procedure:

Part Number Description
1115240-00-A Brush, Disc Brake Caliper
1134786-00-A Caliper Spreader Tool
Informational PurposesAn informational icon, calling your attention
Remarque
For detailed brake specifications, see .

Dépose

  1. Remove the front wheels (voir la procédure).
  2. Remove the pad retaining pins and collect the anti-rattle spring.
    Informational PurposesAn informational icon, calling your attention
    Note
    Always check that the anti-rattle clip has not been damaged. This part is easily damaged and is important to help eliminate squeaks.
  3. Use the caliper spreader tool or similar tool to gently push the pistons back into the caliper.
  4. Remove the brake pads from the caliper.
  5. Check that the caliper pad slides are dirt free and the seals are in good condition.
  6. Repeat steps 2-5 on the other side of the vehicle.

Installation

La procédure d’installation est l’inverse de la procédure de retrait, à l’exception de ce qui suit :
Informational PurposesAn informational icon, calling your attention
Note
Nettoyez les zones touchées avant l'installation.
  • Thoroughly clean the caliper pad slides and abutments with a the disc brake caliper brush (tool part number 1115240-00-A) and brake cleaner.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If there is rust or pitting on the caliper that cannot be removed with a hand brush, replace the caliper (voir la procédure).
  • Apply an even layer of Silaramic lubricant (1063021-00-A) to the caliper pad slides and between the shim and the backing plate. Remove any excess lubricant.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Ensure that the brake pads move freely.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not apply copper paste to the caliper, seals, or any component other than the shim and backing plate.
  • Pump the brake pedal at least 5 times to seat the pads against the brake rotors.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Vérifiez toujours que les plaquettes de frein sont bien en place avant de conduire le véhicule.
  • Top off the brake fluid level as required.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Si vous renversez du liquide de frein sur une surface peinte, lavez-la immédiatement avec de l'eau propre.
  • Lisser les plaquettes de frein. Voir Plaquettes de frein - Rodage.