20/12/2023 17:14:18

Insulator - Motor Bay - Rear (5 Seat) (Remove & Replace)

Code de correction 15308512

Dépose

  1. Open both falcon doors.
  2. Open the trunk.
  3. Remove the rear load floor.
  4. Remove the trunk gap hider.
  5. Remove the LH and RH trunk sill side trim. See Garniture - coffre arrière - latérale - gauche (retrait et remplacement).
  6. Remove the LH and RH C-pillar mid trim. See Garniture – montant arrière – centrale – gauche (retrait et remplacement).
  7. Release the clip and tabs (x3) that attach the load floor support to the LH and RH lower C-pillar
    Informational PurposesAn informational icon, calling your attention
    Remarque
    3x tabs, 1x clip
  8. Remove LH and RH rear welcome plate. See Plaque de bienvenue - gauche (retrait et remplacement).
  9. Remove the LH and RH lower C-panel trim. See Garniture – montant arrière – inférieure – gauche (retrait et remplacement).
  10. Remove the trunk carpet
  11. Make a relief cut to remove the motor bay insulator from around the HV cables.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    ATTENTION
    Take care to not damage HV cables.
  12. Make a relief cut to remove the motor bay insulator from around the coolant hose
    Warning IconA warning icon, calling your attention to a possibly risky situation
    ATTENTION
    Take care to not damage the coolant hose.
  13. Lift the motor bay insulator up, clearing it from the gap hider brackets.
  14. Remove the motor bay insulator from the vehicle.

Installation

La procédure d'installation se fait en suivant l'ordre inverse de la procédure de retrait.