2025-06-27

Fascia Assembly - Rear - Partially Remove (Mobile Only) (Remove and Install)

Código de corrección 10010501701 0.30 NOTA: Salvo que se indique lo contrario explícitamente en el procedimiento, el código de corrección anterior y el FRT reflejan todo el trabajo necesario para realizar este procedimiento, incluidos los procedimientos vinculados. No acumule códigos de corrección a menos que se le indique explícitamente que lo haga. NOTA: Consulte Tiempos de tarifa plana para obtener más información sobre los FRT y cómo se crean. Para enviar sus comentarios sobre los valores de FRT, escriba a ServiceManualFeedback@tesla.com. NOTA: Consulte Protección personal para asegurarse de llevar el EPI adecuado al realizar el siguiente procedimiento.

  • 2025-06-11: Released new procedure.

Retirar

  1. Release the rear half of the LH and RH rear fender garnish from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Nota
    6x clips, 2x tabs. Release from center of garnish and work your way outward towards the rear. Use a clip prytool to release the clips at the rear of the fascia to avoid damage to the garnish.
  2. Open the liftgate.
  3. Apply masking tape around the LH corner of the rear upper fascia.
  4. Partially release the LH rear trough trim.
    Informational PurposesAn informational icon, calling your attention
    Nota
    3x clips
  5. Remove the bolt that attaches the LH corner of the rear fascia to the body.
  6. Remove the screw that attaches the LH rear fascia to the body.
  7. Repeat steps 3 through 6 at the RH side of the vehicle.
  8. Release rear fascia diffuser
    Informational PurposesAn informational icon, calling your attention
    Nota
    2x fastener covers, 7x bolts, 6x push clips.
  9. Release the rear fascia assembly from the body and tilt it down onto a foam pad.
    Informational PurposesAn informational icon, calling your attention
    Nota
    1x connector. Place the rear fascia on a padded surface to avoid damage.

Instalar

Installation procedure is the reverse of removal, except for the following:
  • Apply threadlocker to the bolts (x7) that attach the rear fascia diffuser to the vehicle.