2026-04-30

3rd row - Outer B-cover - LH (7-Seat)(Remove and Replace)

Código de corrección 1309010701 1309010702 NOTA: Salvo que se indique lo contrario explícitamente en el procedimiento, el código de corrección y el FRT mencionados anteriormente reflejan todo el trabajo necesario para realizar este procedimiento, incluidos los procedimientos vinculados. No acumule códigos de corrección a menos que se le indique explícitamente que lo haga. NOTA: Consulte Tiempos de tarifa plana para obtener más información sobre los FRT y cómo se crean. NOTA: Consulte Protección personal para asegurarse de llevar el EPI adecuado al realizar el siguiente procedimiento. NOTA: Consulte Precauciones ergonómicas para ver información sobre prácticas de trabajo seguras.

Warning IconA warning icon, calling your attention to a possibly risky situation
Aviso
Este procedimiento están en fase PRELIMINAR. Aunque se ha validado, es posible que falten advertencias y precauciones. Siga los requisitos de seguridad y tenga mucho cuidado cuando trabaje en sistemas y componentes de alta tensión o cerca de ellos.
  • 2026-01-26: Released new procedure.
  1. Open all four doors
  2. Lower all four windows
  3. Open liftgate
  4. Remove trunk load floor from vehicle
  5. Move LH front seat forward
  6. Position 60 seat into easy entry mode
    Informational PurposesAn informational icon, calling your attention
    Nota
    Press shoulder switch and push 60 seat forward to position into easy entry mode
  7. Move RH front seat forward
  8. Position 40 seat into easy entry mode
    Informational PurposesAn informational icon, calling your attention
    Nota
    Press shoulder switch and push 40 seat forward to position into easy entry mode
  9. Remove 3rd row seat cushion and disconnect harness
    Informational PurposesAn informational icon, calling your attention
    Nota
    1x connector, Pull LH and RH release lever under 3rd row seat cushion to release seat cushion
  10. Remove 3rd row LH seat cushion bolster
    Informational PurposesAn informational icon, calling your attention
    Nota
    1x bolt, 11mm, 37 Nm, 1x location pin, 1x tab, Slide LH seat cushion bolster towards front of vehicle to remove
  11. Remove LH outer cover
    Informational PurposesAn informational icon, calling your attention
    Nota
    1x clip, 1x tablift/pry front then rear to release cover, slightly recline seat forward for easy removal of rear clip, then push from rear to remove from inner cover.
  12. Install LH outer cover
    Informational PurposesAn informational icon, calling your attention
    Nota
    1x clip, 1x TabInsert outer cover into position and engage rear clip, re-engage front tab of outer cover
  13. Install 3rd row LH seat cushion bolster
    Informational PurposesAn informational icon, calling your attention
    Nota
    1x bolt, 11mm, 37 Nm, 1x location pin, 1x tab, Slide LH seat cushion bolster into seat frame complete
  14. Install 3rd row seat cushion and connect harness
    Informational PurposesAn informational icon, calling your attention
    Nota
    1x connector, Secure 3rd row seat cushion into RH and LH latches
  15. Move 60 seat to original position
  16. Move LH front seat to original position
  17. Move 40 seat to original position
  18. Install trunk load floor onto vehicle
  19. Move RH front seat to original position
  20. Close liftgate
  21. Raise all four windows
    Informational PurposesAn informational icon, calling your attention
    Nota
    Via LH front door switch
  22. Close all four doors
    Informational PurposesAn informational icon, calling your attention
    Nota
    Unlatch doors before closing if necessary