2026-07-28

Headlights (Check Aiming with LET Tool) (Inspection)

Código de corrección 17400800719 FRT 0.12 NOTA: Salvo que se indique lo contrario explícitamente en el procedimiento, el código de corrección y el FRT mencionados anteriormente reflejan todo el trabajo necesario para realizar este procedimiento, incluidos los procedimientos vinculados. No acumule códigos de corrección a menos que se le indique explícitamente que lo haga. NOTA: Consulte Tiempos de tarifa plana para obtener más información sobre los FRT y cómo se crean. NOTA: Consulte Protección personal para asegurarse de llevar el EPI adecuado al realizar el siguiente procedimiento. NOTA: Consulte Precauciones ergonómicas para ver información sobre prácticas de trabajo seguras.

  • 2026-07-10: Released new procedure.

Special tools required for this procedure:

Supplier Part Number Description
Tesla 1133367-00-B LET Headlight Machine SLA 40

Check Headlight Aiming

Warning IconA warning icon, calling your attention to a possibly risky situation
PRECAUCIÓN
When checking the aiming of the headlights, do not set the vehicle to the "Adjust Headlights" mode through the touchscreen. The "Adjust Headlights" mode creates a non-standard headlight beam pattern that should not be used for checking the aiming of the headlights.
  1. Park the vehicle on a flat and level surface.
  2. Make sure that the tire pressures are set to specification.
  3. Open the hood.
  4. Power on the headlight tester.
  5. Position the headlight aimer perpendicular to the vehicle, at a 35 cm distance from the headlight lens.
    Informational PurposesAn informational icon, calling your attention
    Nota
    Use the visor/laser to line up the tester perpendicular to the axis between the hood struts. If the headlight aimer can move between the LH and RH headlights while maintaining the same laser angle projected onto the hood struts, it is set correctly (perpendicular) to the vehicle.
  6. Latch the LH front door.
    Informational PurposesAn informational icon, calling your attention
    Nota
    Latching the LH front door prevents the headlights from shutting off during the procedure.
  7. Turn on the headlights.
  8. Select the "eye" icon on the LET headlight aimer, and then select the left headlight icon.
  9. Select height to <0.8m.
  10. Position the headlight aimer in front of the LH headlight.
    Informational PurposesAn informational icon, calling your attention
    Nota
    Adjust the height of the headlight aimer as needed to align it with the center point of the headlight.
  11. Move the headlight aiming machine following the black arrows on the screen. Once the machine is centered to the headlight, select the "X" button which will direct you to the aiming screen.
  12. Note down the headlight "Y" and "H" values in the internal notes in SCA.
  13. Position the headlight aimer in front of the RH headlight, and then repeat steps #SNY_TJH_XGC__GUID-48F17305-DC40-448C-94C5-E90E352645DE and #SNY_TJH_XGC__GUID-B4502A1D-1AE1-4B34-912E-72A895CC17A4 for the RH headlight.
  14. Unlatch the LH front door.