2026-05-27

Power Strut - Liftgate - LH (Model Y Standard) (Remove and Replace)

Código de corrección 11332902602 FRT 0.24 NOTA: Salvo que se indique lo contrario explícitamente en el procedimiento, el código de corrección y el FRT mencionados anteriormente reflejan todo el trabajo necesario para realizar este procedimiento, incluidos los procedimientos vinculados. No acumule códigos de corrección a menos que se le indique explícitamente que lo haga. NOTA: Consulte Tiempos de tarifa plana para obtener más información sobre los FRT y cómo se crean. NOTA: Consulte Protección personal para asegurarse de llevar el EPI adecuado al realizar el siguiente procedimiento. NOTA: Consulte Precauciones ergonómicas para ver información sobre prácticas de trabajo seguras.

  • 2026-05-07: Released new procedure.

Retirar

  1. Open the liftgate and support it with a telescoping hood prop.
  2. Fold 2nd row LH seatback down
    Informational PurposesAn informational icon, calling your attention
    Nota
    Protect seat back upholstery if necessary
  3. Remove the LH rear body primary seal. See Primary Body Seal - Rear - LH (Remove and Replace).
  4. Partially remove the LH trunk side trim. See Trunk Side Trim LH - Rear Under Body (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Nota
    Release only the upper section of trim, Use caution to avoid straining 12v socket harness at rear of trim, All clips and datums shown in image for clarity
  5. Remove the LH upper C-pillar trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).
  6. Release the rear LH section of the headliner.
    Informational PurposesAn informational icon, calling your attention
    Nota
    3x clips, 1x guide pin, Pull down as required to provide access to power strut connector.
  7. Disconnect the power strut connector from the body harness.
  8. Release the LH rear power strut harness grommet from the body.
  9. Release the LH upper power strut clip from the liftgate side ball stud, and lay the power strut down on the door jamb.
  10. Release the power strut clip from the body side ball stud.

Instalar

  1. Install the power strut clip to the body side ball stud.
    Informational PurposesAn informational icon, calling your attention
    Nota
    Ensure that the spring clip is reset.
  2. Install the power strut clip to the liftgate side ball stud.
    Informational PurposesAn informational icon, calling your attention
    Nota
    Ensure that the spring clip is reset.
  3. Remove the telescoping hood prop from the vehicle.
  4. Insert the power strut harness into the body and install the grommet.
  5. Connect the power strut harness connector.
  6. Install the rear LH section of the headliner.
  7. Install the LH upper C-pillar trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).
  8. Secure the LH trunk side trim. See Trunk Side Trim LH - Rear Under Body (Remove and Replace).
  9. Install the LH rear body primary seal. See Primary Body Seal - Rear - LH (Remove and Replace).