2025-10-24

ECU - Enganche de remolque (Desinstalación y sustitución)

Código de corrección 12302102 0.18 NOTA: Salvo que se indique lo contrario explícitamente en el procedimiento, el código de corrección anterior y el FRT reflejan todo el trabajo necesario para realizar este procedimiento, incluidos los procedimientos vinculados. No acumule códigos de corrección a menos que se le indique explícitamente que lo haga. NOTA: Consulte Tiempos de tarifa plana para obtener más información sobre los FRT y cómo se crean. Para enviar sus comentarios sobre los valores de FRT, escriba a ServiceManualFeedback@tesla.com. NOTA: Consulte Protección personal para asegurarse de que lleva puesto el EPI adecuado al realizar el siguiente procedimiento.

Remove

  1. Open the LH front door.
  2. Lower the LH front window.
  3. Raise and support the vehicle. See Elevación del vehículo - Elevador de 2 columnas.
  4. Set the vehicle to a comfortable working height, then lower it onto the lift locks.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    PRECAUCIÓN
    Make sure there's an audible click of the locks on both sides before lowering. Otherwise, the vehicle may tilt to the side.
  5. Remove the tow hitch cover screws (x2) and disconnect the tabs (x10). Remove the tow hitch cover.
  6. Disconnect the connectors (x2) from the trailer hitch ECU.
  7. Remove the 10 mm retaining nut, then remove the trailer hitch ECU.

Install

  1. Install the trailer hitch ECU, then torque the 10 mm nut.
    6 Nm (4.4 lbs-ft)
  2. Connect the trailer hitch ECU connectors (x2).
  3. Install the tow hitch cover. Tighten the captive screws (x2) and engage the tabs (x10).
  4. Fully lower the vehicle.
  5. Remove the vehicle from lift. See Elevación del vehículo - Elevador de 2 columnas.
  6. Raise the LH front window.
  7. Close the LH front door.