10/02/2017 09:09:31

Transmitter - Remote Keyless Entry (RKE) - Replace / Reprogram

Correction code 17031102

Synchronize

  1. Remove lower steering column shroud (refer to procedure).
  2. Connect the white antenna connectors.
  3. The receiver will softly beep 4 times, then will beep louder one more time to indicate that it is ready to receive the first transmitter's button codes.
  4. Disconnect the antenna connectors.
  5. Press the buttons on the first transmitter in this sequence: LOCK button, UNLOCK button then the programmable button.
  6. The unit will beep once when the LOCK button is learned, twice for the UNLOCK button code and then 3 times for the Programmable button.
    Informational PurposesAn informational icon, calling your attention
    Note
    Any number of buttons may be learned (i.e.- only one button, only two buttons, all three buttons) for each transmitter that is programmed into the receiver.
  7. To program additional transmitters, connect and disconnect the antenna connectors.
  8. The receiver will beep twice to indicate that it is ready to learn the second transmitter's button codes (three times for a third transmitter and four times for a fourth transmitter).
  9. Repeat steps 2 to 6 for each additional transmitter.
  10. The receiver automatically exits the programming mode after 10 seconds if no programming signal is detected.
  11. Make sure that the antenna connectors are disconnected then install the lower steering column shroud (refer to procedure).