10/02/2017 09:09:31

Master Cylinder

Correction code 33030102

Remove

  1. Remove rear condenser exit duct (refer to procedure).
  2. Clamp brake reservoir hoses.
    Informational PurposesAn informational icon, calling your attention
    Note
    Place suitable absorbent material around the affected area to absorb any possible fluid spillage.
  3. Release clips (x2) securing reservoir hoses to master cylinder and disconnect hoses from master cylinder.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Plug pipe connections to prevent ingress of moisture or dirt.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If brake fluid spills on the paintwork, wash the area immediately with clean water.
  4. Release brake pipe unions (torque 14 Nm).
  5. Remove nuts and washers (x2) securing master cylinder to servo (torque 25 Nm).
  6. Remove master cylinder.

Install

Installation procedure is the reverse of removal, except for the following:

  1. Bleed brake system (refer to procedure).