10/02/2017 09:09:31

Solenoid Valve - Evaporator - Roadster 2.x

Correction code 18035502

Remove

  1. Remove receiver drier (refer to procedure).
  2. Disconnect union securing low pressure pipe to T-piece (torque 18 Nm).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    To prevent damage always use a suitable wrench to hold backing nut when loosening pipes and unions.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Plug pipe connections to prevent ingress of moisture or dirt.
  3. Disconnect solenoid valve harness connector.
  4. Loosen solenoid rear pipe retaining nut (torque 18 Nm).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    To prevent damage always use a suitable wrench to hold backing nut when loosening pipes and unions.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Plug pipe connections to prevent ingress of moisture or dirt.
  5. Loosen front pipe union and disconnect pipe from solenoid valve (torque 18 Nm).
  6. Remove bolts (x2) securing solenoid valve bracket to body (torque 10 Nm).
  7. Remove solenoid valve and bracket assembly.
  8. Note orientation of valve and bracket to aid installation.
  9. Remove bolts (x2) securing valve to bracket (torque 8 - Nm.).

Install

Installation procedure is the reverse of removal, except for the following:

  1. Replace A/Cpipe O-rings.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lubricate new O-ring seals with clean refrigerant oil.