10/02/2017 09:09:31

CV Joint Assembly - Outer - LH

Correction code 47150902

Remove

  1. Remove driveshaft assembly (refer to procedure).
  2. Position driveshaft in a vice.
  3. Remove and discard clips (x2) securing gaiter to CV joint.
  4. Slide gaiter along shaft to gain access to joint.
  5. Flex the joint to expose the inner face of the joint.
  6. Using a suitable drift positioned against the inner face of the joint, knock the CV joint of the driveshaft.
  7. Remove circlip from driveshaft and discard.

Install

Installation procedure is the reverse of removal, except for the following:

  1. Clean driveshaft, CV joint and gaiter. If refitting a CV joint, remove all old grease from joint using a solvent based cleaner.
  2. Fit new circlip to driveshaft.
  3. Inspect gaiter for damage and replace if necessary.
  4. Push CV joint onto driveshaft and make sure that it is securely retained by the circlip.
  5. Apply 120 grams of recommended grease to CV joint and gaiter. Approximately 50 grams to the joint and 70 grams to the gaiter.
  6. Position gaiter and secure with new clips.