29/12/2017 10:22:42

ABS Modulator Assembly

Correction code 33032502

Remove

  1. Raise and support vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning

    Do not work on an incorrectly supported vehicle.

  2. Remove lower LH wheel arch liner (refer to procedure).
  3. Release brake pipes (x6) from modulator (torque 14 Nm).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Plug pipe connections to prevent ingress of moisture or dirt.
    Informational PurposesAn informational icon, calling your attention
    Note
    Place suitable absorbent material around the affected area to absorb any possible fluid spillage.
  4. Remove Patchbolts (x3) securing modulator to mounting bracket (torque 9 Nm).
  5. Remove bolts (x3) securing modulator to damper bracket rubber mountings and remove bracket (torque 9 Nm).
  6. Disconnect ABS connector and remove modulator.

Install

Installation procedure is the reverse of removal, except for the following:

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION

Replace all patchbolts.

  1. Bleed brakes (refer to procedure).