2017-02-10

Seat Assembly - Passenger - Roadster 2.x

Correction code 13021002

Remove

  1. Remove soft top or hard top if applicable.
  2. Remove rear center console (refer to procedure).
  3. Remove clip and clevis pin securing park brake primary cable to park brake lever mechanism.
  4. Disconnect park brake lever switch connector.
  5. Remove bolts (x4) securing seat rail to floor panel (torque 25 Nm).
  6. Remove bolt, spring washer and spacer sleeve securing seat belt lower anchor point to seat frame (torque 33 Nm).
  7. Disconnect seat heater connector.
  8. Remove seat from vehicle.
  9. Remove bolt, washer and spring securing seat belt buckle (torque 33 Nm). Remove seat belt buckle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Always record quantity and fitted position of shims, washers, locktabs or clips.
  10. Release clip securing lumbar pump hose to seat frame.
  11. Drill out rivets (x4) securing owner manual holder to seat assembly and remove owner manual holder.
  12. Remove nuts (x2) securing seat assembly to seat frame (torque 15 Nm).
  13. Remove RH bolt securing seat rail to seat assembly (torque 15 Nm).
  14. Remove LH bolt securing seat assembly to seat rail (torque 15 Nm).
  15. Remove seat rail from seat assembly.

Install

  1. Installation procedure is reverse of removal.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION

    Make sure not to damage wires.