23/06/2017 11:31:10

Driver Airbag

Correction code 17063102

Remove

  1. Remove starter key and wait 30 seconds to allow SRS circuits to fully discharge before commencing work.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    To avoid personal injury, observe all relevant safety precautions before removing or testing any SRS components
  2. Remove lower steering column shroud (refer to procedure).
  3. Disconnect yellow airbag SRS harness connector.
  4. Remove retaining screws (x2) and release airbag from steering wheel.
  5. Disconnect airbag connector and remove airbag.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Store the airbag module with the deployment side facing up. This will prevent it being propelled if accidentally deployed which may cause injury.

Install

Installation procedure is the reverse of removal.