09/09/2019 13:44:55

Roll Hoop Cover Assembly

Correction code 10200512

Remove

  1. Remove soft top or hard top if applicable.
  2. Remove high mounted brake lamp (refer to procedure).
  3. Remove bolts and washers (x2) securing RH and LH soft top latches and remove the latches.
    Informational PurposesAn informational icon, calling your attention
    Note
    LH shown RH similar.
  4. Release rear door/roof seal adhesive and the fitting lugs (x2) a sufficient amount to remove the cover.
    Informational PurposesAn informational icon, calling your attention
    Note
    A new seal may be required if its fixing adhesive is insufficient to secure it in position.
  5. Remove the bolts and washers (x5) securing roll hoop cover to upper bulkhead.
  6. Remove roll hoop cover.

Install

Installation procedure is the reverse of removal, except for the following:

  1. Make sure that courtesy light and high mounted stop lamp harness is routed under the roll hoop cover and not visible when viewed through the rear window.