10/02/2017 09:09:31

Module - Motor Encoder - Roadster 2.x

Correction code 40012702

Remove

  1. Remove lower motor shroud (refer to procedure).
  2. Remove screw (x2) securing encoder harness P-clips and ground lead to motor housing.
    Informational PurposesAn informational icon, calling your attention
    Note
    When installing, apply Loctite®222™ thread locking compound to bolt/screw threads.
  3. Remove P-clips (x2) from harness.
  4. Remove cable ties and disconnect RTD sensor connector.
  5. Remove screws (x4) securing encoder to motor (torque - 1.3 Nm).
    Informational PurposesAn informational icon, calling your attention
    Note
    When installing, apply Loctite®222™ thread locking compound to bolt/screw threads.
  6. Release and remove encoder from motor.

Install

Installation procedure is the reverse of removal.