10/02/2017 09:09:31

Hose - Vacuum Pump to Servo - Roadster 2.x

Correction code 33033702

Remove

  1. Raise and support vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning

    Do not work on an incorrectly supported vehicle.

  2. Remove LH lower wheel arch liner (refer to procedure).
  3. Remove condenser rear exit duct (refer to procedure).
  4. Remove cover and NVH foams from vacuum pump.
  5. Disconnect vacuum hose from brake vacuum pump.
  6. Disconnect vacuum hose from brake servo.
  7. Maneuver pipe through grommet in bumper armature and remove hose.

Install

Installation procedure is the reverse of removal, except for the following:

  1. Make sure that the servo operates correctly before driving the vehicle.
  2. Make sure that the NVH foams and cover are correctly fitted and secured to the vacuum pump. Incorrectly fitted, or missing NVH foam can result in excessive noise when the pump is operating.