10/02/2017 09:09:31

Cable - High Voltage - PEM to Motor - Roadster 2.x

Correction code 17013602

Remove

  1. Remove lower motor shroud (refer to procedure).
  2. Remove screws (x5) securing cable cover to motor (torque 2 Nm).
    Informational PurposesAn informational icon, calling your attention
    Note
    When installing, apply Loctite®222™ thread locking compound to bolt/screw threads.
  3. Remove cable cover.
  4. Remove Nomex insulator.
  5. Remove brass bolts (x3), copper washers, and serrated Belleville washers (torque 17 Nm).
    Informational PurposesAn informational icon, calling your attention
    Note
    The serrated Belleville washers must be fitted with the raised inner diameter against the bolt head.
  6. Remove screws (x2) securing cable shield to motor.
  7. Release cable shield and grommet from motor and remove motor cable.
  8. Remove grommet from motor cable.

Install

Installation procedure is the reverse of removal, except for the following:

  1. Apply a light coating of Kopr-Shield™ Compound to face of motor terminals.
  2. Clean and inspect Nomex insulator for damage and replace if necessary.
  3. Make sure that cable grommet is correctly installed on cable and motor.