10/02/2017 09:09:31

Receiver Drier - Roadster 1.5

Correction code 18032602

Remove

  1. Recover the A/C refrigerant (refer to procedure).
  2. Remove HVAC high voltage controller (refer to procedure).
  3. Note fitted (inlet/outlet) position of receiver drier pipes, clamp and arrow denoting direction of flow.
  4. Loosen refrigerant pipe unions (x2) at the receiver drier (torque 18 Nm).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Plug pipe connections to prevent ingress of moisture or dirt.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    To prevent damage always use a suitable wrench to hold backing nut when loosening pipes and unions.
  5. Remove bolts (x2) and nuts (x2) securing condenser to body (torque 12 Nm). Maneuver condenser to allow pipes to be released from receiver drier.
  6. Loosen clamp, disconnect pipes and remove receiver drier.

Install

Installation procedure is the reverse of removal, except for the following:

  1. Replace A/C pipe O-rings.