10/02/2017 09:09:31

Drive Coupler - Motor to Transmission - Roadster 2.x

Correction code 47030802

Remove

  1. Remove insulator ring from transmission (refer to procedure).
  2. Observing the installed orientation, remove drive coupler from transmission input shaft.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    The drive coupler is secured to the transmission input shaft by a snap ring. If it cannot be removed by hand, a suitable puller should be used.

Install

Installation procedure is the reverse of removal, except for the following:

  1. Check condition of coupler snap ring on input shaft.
  2. Clean splines on input shaft and apply recommended grease.
  3. Install drive coupler onto input shaft.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    The transmission input shaft has a master spline that will only allow the drive coupler to be fitted in one position. Never force the drive coupler onto the input shaft.