10/02/2017 09:09:31

Wiper Motor Assembly - Roadster 1.5

Correction code 17210102

Remove

  1. Release and lift hood.
  2. Remove wiper arm nut cover and lift wiper arm.
  3. Mark fitted position of wiper arm to wiper spindle.
  4. Remove nut securing wiper arm to wiper spindle, maneuver arm to break taper and remove arm.
  5. Remove HVAC controller (refer to procedure).
  6. Loosen clamps securing inlet hose and remove hose.
    Informational PurposesAn informational icon, calling your attention
    Note
    Cover outlet duct to prevent foreign material falling into the HVAC assembly.
  7. Remove screws (x2) securing wiper motor cover to body.
  8. Remove cable tie securing cover to wiper motor and remove cover.
  9. Remove cable tie securing wiper motor connector and disconnect connector.
  10. Disconnect washer hoses from washer jets, release clip and position pipe aside.
  11. Remove nut securing RH washer jet and remove jet.
  12. Remove sealing ring from wiper spindle.
  13. Remove Allen bolts (x3) securing wiper linkage to body (torque 25 Nm).
  14. Using a suitable tool move wiper linkage to opposite end stop to aid removal.
  15. Maneuver wiper motor out from under scuttle panel.

Install

Installation procedure is the reverse of removal, except for the following:

  1. Check and adjust washer jet.