10/02/2017 09:09:31

Seat Assembly - Driver

Correction code 13020102

Remove

  1. Remove soft top or hard top if applicable.
  2. Remove LH rear bolt securing seat rail to floor panel (torque 25 Nm). Collect seat rail runner stop.
  3. Remove RH rear bolt securing seat rail to floor panel (torque 25 Nm). Collect seat rail runner stop.
  4. Remove front seat rail bolts (x2) securing seat rail to floor panel (torque 25 Nm).
  5. Remove bolt, washer and spacer securing seat belt lower anchor point to seat frame (torque 33 Nm).
  6. Disconnect seat heater connector and seat belt connector.
  7. Remove seat from vehicle.
  8. Remove bolt, washer and spring securing seat belt buckle to seat frame (torque 33 Nm). Remove seat belt buckle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Always record quantity and fitted position of shims, washers, locktabs or clips.
  9. Remove RH rear bolt securing seat assembly to seat frame (torque 15 Nm).
  10. Remove LH rear bolt securing seat assembly to seat frame and release lumbar valve (torque 15 Nm).
  11. Remove nuts (x2) securing seat rail to seat assembly (torque 15 Nm). Remove seat rail from seat assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Always record quantity and fitted position of shims, washers, locktabs or clips.
  12. Remove seat rail from seat assembly.

Install

  1. Installation procedure is reverse of removal.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION

    Make sure not to damage wires.