10/02/2017 09:09:31

Upright - Suspension - LH

Correction code 31010102

Remove

  1. Raise and support vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning

    Do not work on an incorrectly supported vehicle.

  2. Remove the wheel (torque 105 Nm).
  3. Remove hub (refer to procedure).
  4. Remove bolts (x2) securing steering arm to upright, move wheel speed sensor bracket aside and collect shims (torque 68 Nm).
    Informational PurposesAn informational icon, calling your attention
    Note
    Always record quantity and fitted position of shims, washers, locktabs or clips.
    Informational PurposesAn informational icon, calling your attention
    Note
    When installing, apply Loctite®242™ thread locking compound to bolt/screw threads.
  5. Remove Nyloc nut securing lower wishbone ball joint to upright (torque 55 Nm).
  6. Using a suitable tool, release ball joint from upright and remove upright.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    To avoid serious injury, use appropriate equipment to carry out this operation.

Install

Installation procedure is the reverse of removal, except for the following:

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION

Replace all nyloc nuts.

  1. Perform a wheel alignment.