18/05/2017 18:10:58

Brake Pads - Rear - Set - Roadster 1.5

Correction code 33010802

Remove

Remove brake reservoir cap and place absorbent material around aperture.

CAUTION
If brake fluid spills on the paintwork, wash the area immediately with clean water.
Raise and support vehicle.

Warning

Do not work on an incorrectly supported vehicle.
Remove the wheel (torque 105 Nm).
Release brake pad retaining pins from clips.
Disconnect park brake inner cables from caliper levers.
Release cable rubber seals and disconnect park brake outer cables from calipers.
Release clips securing brake hoses to track control arms.
Remove upper bolts securing calipers to uprights (torque 45 Nm).

Note
When installing, apply Loctite®680™ retaining compound to bolt/screw threads.
Remove lower bolts securing calipers to uprights and release calipers (torque 25 Nm).

Note
When installing, apply Loctite®680™ retaining compound to bolt/screw threads.
Remove pad retaining pins and collect pads and anti-rattle springs.

Note
Always record quantity and fitted position of shims, washers, locktabs or clips.
Open bleed screw and connect bottle for waste brake fluid.
Use suitable tool, turn pistons clockwise to fully retract into calipers.

Warning
To avoid serious injury, use appropriate equipment to carry out this operation.
Tighten bleed screw.
Check caliper slides are free to move and seals are in good condition.

Installation procedure is the reverse of removal, except for the following:

Clean and lubricate caliper slides and pads using suitable products prior to installation.
Pump brake pedal at least 5 times to seat pads against brake discs.

Warning
Always check that brake pads are seated correctly before driving the vehicle.
Top-up brake fluid level as required.
Check park brake adjustment.