10/02/2017 09:09:31

HVAC Assembly - Roadster 1.5

Correction code 18010302

Remove

  1. Remove solenoid valve to front TXV pipe (refer to procedure).
  2. Loosen clamps (x2) securing Air Distribution Unit (ADU) inlet hose. Remove hose.
  3. Remove cable ties (x2) securing harness to HVAC assembly.
  4. Remove Patchbolts (x2) securing HVAC assembly to body (torque 15 Nm).
  5. Disconnect harness connectors (x2) from evaporator thermal switch.
  6. Release harness edge clips (x3) from body and remove cable ties (x3) securing harness to body.
  7. Disconnect harness connectors (x2) from HVAC assembly.
  8. Release clips (x2) securing blower motor to HVAC assembly.
  9. Raise and support vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning

    Do not work on an incorrectly supported vehicle.

  10. Remove RH front the wheel (torque 105 Nm).
  11. Remove cable tie securing drain tube to body.
  12. Affix a draw string to end of drain tube to allow drain tube to be installed correctly.
  13. Release HVAC assembly from blower motor and maneuver upwards, withdrawing drain tube from body.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION

    Make sure not to damage components.

  14. Remove HVAC assembly from vehicle.

Install

Installation procedure is the reverse of removal, except for the following:

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION

Replace all patchbolts.