10/02/2017 09:09:31

Transmission Assembly - Replace - Roadster 2.x

Correction code 47030602

Remove

  1. Remove drive coupler from transmission (refer to procedure).
  2. Disconnect harness connector from parking pawl mechanism.
  3. Remove cable ties (x2) securing harness to transmission and remove harness.
  4. Remove bolts securing transmission to support cradle 1001024 (Power Train Support Cradle).
  5. Using assistance, remove transmission from support cradle.

Install

Installation procedure is the reverse of removal, except for the following:

  1. Install the power train in the vehicle and fill the transmission with the recommended quantity and specification of fluid.
  2. With the vehicle on the ramp and the rear wheels removed, run the motor and transmission in drive 'D' for approximately 1 minute.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Always run a new transmission in 'D' (Drive) for at least 1 minute to make sure that fluid is circulated to all areas of the transmission. The transmission fluid pump does not operate when 'R' (Reverse) is selected and damage may occur to the transmission.
    Informational PurposesAn informational icon, calling your attention
    Note
    Traction control will need to be switched off to allow the rear hubs to rotate when the vehicle is suspended on the ramp.
  3. Check for signs of any fluid leaks before reinstalling the middle undershield.