10/02/2017 09:09:31

Wishbone Assembly - Rear - Upper - RH

Correction code 31031702

Remove

  1. Raise and support vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning

    Do not work on an incorrectly supported vehicle.

  2. Remove the wheel (torque 105 Nm).
  3. Disconnect wheel speed sensor multiplug, unclip harness from bracket and remove cable tie.
  4. Remove bolts (x2) securing ball joint carrier to upright move wheel speed sensor bracket aside and collect shims (torque 68 Nm).
    Informational PurposesAn informational icon, calling your attention
    Note
    Always record quantity and fitted position of shims, washers, locktabs or clips.
  5. Release wishbone fixing lock tabs from bolts (x4).
    Informational PurposesAn informational icon, calling your attention
    Note
    Always record quantity and fitted position of shims, washers, locktabs or clips.
  6. Remove wishbone (Bolts & nuts x2, washer x1, lock tabs x4) (torque 45 Nm).
    Informational PurposesAn informational icon, calling your attention
    Note
    Always record quantity and fitted position of shims, washers, locktabs or clips.
  7. Remove carrier ball joint from wishbone (nut x1) (torque 55 Nm).

Install

Installation procedure is the reverse of removal, except for the following:

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Only tighten wishbone pivot bolts when the suspension is in ride height position. This can be achieved by either using the ride height tools or when the vehicle is on its wheels.
  1. Carry out Geometry check.