29/12/2017 10:23:09
Pipe - High Pressure - Condenser to Receiver Drier - Roadster 2.x
Correction code 18035702
Remove
- Recover the A/C refrigerant (refer to procedure).
- Remove HVAC controller (refer to procedure).
-
Disconnect pressure transducer harness connector.
-
Loosen union securing pipe to condenser (torque 18 Nm).
CAUTIONTo prevent damage always use a suitable wrench to hold backing nut when loosening pipes and unions.CAUTIONPlug pipe connections to prevent ingress of moisture or dirt.
-
Remove bolts and nuts (x4) securing condenser to body (torque 12 Nm). Collect spacers (x4).
- Maneuver condenser up and forward to allow the high pressure pipe to be removed.
-
Remove pressure transducer from pipe.
CAUTIONTo prevent damage always use a suitable wrench to hold backing nut when loosening pipes and unions.CAUTIONPlug pipe connections to prevent ingress of moisture or dirt.
- Remove charge port cap if applicable.
Install
Installation procedure is the reverse of removal, except for the following:
-
Replace all pipe O-rings.
NoteLubricate new O-ring seals with clean refrigerant oil.