10/02/2017 09:09:31

Track Control Arm Assembly - LH

Correction code 31032002

Remove

  1. Raise vehicle on 2 post on lift (refer to procedure).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning

    Do not work on an incorrectly supported vehicle.

  2. Remove bolts (x5) securing rear diffuser tray to rear diffuser trim (torque 8 Nm).
  3. Remove rear diffuser tray.
  4. Remove the wheel (torque 105 Nm).
  5. Remove Nyloc nut and bolt securing lower wishbone/track control arm to subframe (torque 60 Nm).
  6. Release brake hose clip from track control arm.
  7. Remove nut securing track control arm to upright (torque 45 Nm).
  8. Using a suitable tool, release track control arm from upright and remove from subframe.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    To avoid serious injury, use appropriate equipment to carry out this operation.

Install

Installation procedure is the reverse of removal, except for the following:

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
Only tighten wishbone pivot bolts when the suspension is in ride height position. This can be achieved by either using the ride height tools or when the vehicle is on its wheels.
Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION

Replace all nyloc nuts.

  1. Perform a wheel alignment.