10/02/2017 09:09:31

Pipe - Evaporator - Solenoid Valve to TXV - Roadster 1.5

Correction code 18032502

Remove

  1. Remove receiver drier (refer to procedure).
  2. Remove insulation pad.
  3. Loosen union between the low pressure manifold and the manifold to compressor pipe (torque 35 Nm). Disconnect pipe.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    To prevent damage always use a suitable wrench to hold backing nut when loosening pipes and unions.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Plug pipe connections to prevent ingress of moisture or dirt.
  4. Loosen union securing the low pressure manifold to the low pressure line (torque 35 Nm). Disconnect pipe.
  5. Remove screw securing the retaining plate to the TXV (torque 10 Nm).
  6. Collect the retaining plate. Remove the low pressure manifold to compressor pipe from the TXV.
  7. Loosen union securing pipe to solenoid valve (torque 18 Nm).
  8. Remove pipe - solenoid valve to evaporator TXV.

Install

Installation procedure is the reverse of removal, except for the following:

  1. Replace A/C pipe O-rings.