10/02/2017 09:09:31

Upright - Suspension - Rear - LH

Correction code 31030102

Remove

  1. Remove hub (refer to procedure).
  2. Remove nut securing track control arm to upright (torque 45 Nm).
  3. Using a suitable tool, release track control arm from upright.
  4. Remove bolts (x2) securing ball joint carrier to upright (torque 68 Nm). Move wheel speed sensor bracket aside and collect shims.
    Informational PurposesAn informational icon, calling your attention
    Note
    Always record quantity and fitted position of shims, washers, locktabs or clips.
    Informational PurposesAn informational icon, calling your attention
    Note
    When installing, apply Loctite®242™ thread locking compound to bolt/screw threads.
  5. Remove nut securing upright to lower wishbone (torque 45 Nm).
  6. Using a suitable tool, release upright from lower wishbone and remove.

Install

Installation procedure is the reverse of removal, except for the following:

  1. Perform a wheel alignment.