02/12/2022 11:39:51

Bisagra - Puerta - Trasera - Inferior - Lado izquierdo (Desinstalación y sustitución)

Código de corrección 11337002 0.24 NOTA: Salvo que se indique lo contrario explícitamente en el procedimiento, el código de corrección anterior y el FRT reflejan todo el trabajo necesario para realizar este procedimiento, incluidos los procedimientos vinculados. No acumule códigos de corrección a menos que se le indique explícitamente que lo haga.NOTA: Consulte Tiempos de tarifa plana para obtener más información sobre los FRT y cómo se crean. Para enviar sus comentarios sobre los valores de FRT, escriba a LaborTimeFeedback@tesla.com. NOTA: Consulte Protección personal para asegurarse de llevar el EPI adecuado al realizar el siguiente procedimiento.

Retirar

  1. Open the LH front and door and lower the LH front and rear windows.
  2. Apply tape to the rear door to mark the lower hinge location.
  3. Apply tape to the body to mark the rear lower hinge location.
  4. Use a jack to support the LH rear door from the bottom.
    Informational PurposesAn informational icon, calling your attention
    Nota
    Make sure to use soft material to protect the painted surface.
  5. Remove the bolts (x2) that attach the lower door hinge to the LH rear door.
  6. Remove the nuts (x2) that attach the rear lower door hinge to the body, and then remove the LH rear lower door hinge from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Nota
    Support the door hinge to make sure it does not fall in the door jam.

Instalar

  1. Align the new lower hinge with the applied tape on the body, and then install the nuts that attach the lower door hinge to body hand tight.
  2. Align the new lower hinge with the applied tape on the LH rear door, and then install the bolts that attach the lower hinge to the LH rear door hand tight.
  3. Close the LH front and rear doors, and then check for gap and flushness. Adjust if necessary.
  4. Tighten the bolts (x2) and nuts (x2) that attach the LH rear door lower hinge to the door and the body.
    27 Nm (19.9 lbs-ft)
    27 Nm (19.9 lbs-ft)
  5. Remove the tape from the LH body side and the LH rear door.
  6. Clean the hinge bolts with IPA.
    Informational PurposesAn informational icon, calling your attention
    Nota
    Allow 1 minute dry time
  7. Apply touch up paint to bolt heads if necessary, and then allow paint to dry.
  8. Raise both LH windows and close both LH doors.