09/09/2024 21:16:36

TPMS BLE (Retroadaptación)

Código de corrección 34040006 1.14 NOTA: Salvo que se indique lo contrario explícitamente en el procedimiento, el código de corrección anterior y el FRT reflejan todo el trabajo necesario para realizar este procedimiento, incluidos los procedimientos vinculados. No acumule códigos de corrección a menos que se le indique explícitamente que lo haga.NOTA: Consulte Tiempos de tarifa plana para obtener más información sobre los FRT y cómo se crean. Para enviar sus comentarios sobre los valores de FRT, escriba a LaborTimeFeedback@tesla.com. NOTA: Consulte Protección personal para asegurarse de llevar el EPI adecuado al realizar el siguiente procedimiento.

Retroadaptar

  1. Remove the TPMS sensor from the wheel. See Sensor - TPMS (Desinstalación y sustitución).
  2. Use an IPA wipe to thoroughly clean the inside and outside of the TPMS sensor mounting hole.
  3. Install the BLE TPMS sensor so that it fits closely to the wheel.
  4. Install the nut that secures the BLE TPMS sensor to the wheel.
    8 Nm (5.9 lbs-ft)
  5. Release the upper bead roller, and allow the bead to seat against the wheel.
  6. Inflate the tire to seat the bead.
  7. Install the valve stem core, and then remove the wheel from the tire changer.
  8. Rebalance the wheel. See Neumático - Delantero - Izquierdo (Equilibrado).
  9. Reinstall the wheel. See Conjunto de rueda (Desinstalación e instalación).
  10. Repeat steps 1 through 9 for all wheels.
  11. Update the Vehicle Configuration. See TPMS BLE (Actualizar configuración).
  12. Test drive the vehicle to at least 15 mph (24 kph) for 1-3 minutes to reconnect the TPMS sensors.
  13. Confirm on the vehicle touchscreen that all 4 TPMS sensors are providing tire pressure readings.