07/03/2019 10:19:51

Soporte - Placa de matrícula - Delantera (EMEA) (Retroadaptación con plantilla)

Código de corrección 12070126 0.12 NOTA: Salvo que se indique lo contrario explícitamente en el procedimiento, el código de corrección anterior y el FRT reflejan todo el trabajo necesario para realizar este procedimiento, incluidos los procedimientos vinculados. No acumule códigos de corrección a menos que se le indique explícitamente que lo haga.NOTA: Consulte Tiempos de tarifa plana para obtener más información sobre los FRT y cómo se crean. Para enviar sus comentarios sobre los valores de FRT, escriba a LaborTimeFeedback@tesla.com. NOTA: Consulte Protección personal para asegurarse de llevar el EPI adecuado al realizar el siguiente procedimiento.

  • 1496772-00-A Plantilla del soporte de la placa de matrícula delantera, Model 3, EMEA

Conectar Procedimiento

  1. Clean the front center surface of the front fascia with isopropyl alcohol (IPA) wipe, and then allow surface to dry before continuing.
  2. Put the front license plate bracket on the jig: Line up the 2 holes on the front license plate bracket with the alignment pins on the jig.
  3. Put the jig on the front fascia: Line up the center indicator (cut out slit) with the center of the front fascia grille.
    Informational PurposesAn informational icon, calling your attention
    Note
    Apply enough force on the head of the jig causing an even contact surface with the front fascia grille and the front license plate bracket.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure to hold the jig by placing your hand on the head of the jig.
  4. Wear eye and ear protection before continuing.
  5. Use a 7/64 in (3 mm) drill bit to drill 4 holes through the front fascia.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Only drill through the top surface of the front fascia. Drilling too far can result in damage to the vehicle.
  6. Install the self tapping screws (part number 1104972-00-A) (x4) that attach the front license plate bracket to the front fascia.
    1 Nm (.7 lbs-ft)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not over torque the screws to prevent damage to the front fascia.
  7. Remove the jig by sliding it out from the front fascia grille